Thanks, I'll check it out.
On Thu, Oct 3, 2019 at 3:42 PM Diego Leñero <dielenram(a)gmail.com> wrote:
Hi,
I experienced the same problem and Kevin Redon solved it. As per his words
"The only cause I could find is an accidental short between the ERASE and
nearby 3.3V pin (on top of the board)." And he was right. He documented the
solution:
1st reflash the DFU bootloader
https://osmocom.org/projects/simtrace2/wiki/Flashing#SAM-BA
2nd flash the application firmware
https://osmocom.org/projects/simtrace2/wiki/Flashing#DFU
I hope this helps,
Diego.
El jue., 3 oct. 2019 a las 21:25, super sad (<supersupersadguy23(a)gmail.com>)
escribió:
Hello,
We have simtrace v2. When we connect the device through USB to a laptop
it does not respond. None of the lights turn on. It does not respond to any
commands. ./simtrace2-lists shows Device = 0.
Can you give us some suggestions on how to use the device and if this is
the normal behavior?
Thank you for your time.