Hi, I was following your mails about your results for the ouput power but I don't understand how you change it. I was checking the code but I didn't find how to change TX0 output power. I tried to change the line : abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_30mW); with abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_250mW); in the "create_objects" fonction but I don't know how the fonction is loaded, I don't know how the bs11 enter the state "BS11_STATE_WAIT_MIN_CFG_2" case BS11_STATE_WAIT_MIN_CFG_2: bs11cfg_state = STATE_SWLOAD; rc = create_objects(g_bts); break; If anyone can help me Thanks a lot Eric Cathelinaud
On Mon, Jun 22, 2009 at 03:22:50PM +0200, Eric Cathelinaud wrote:
Hi,
I was following your mails about your results for the ouput power but I don't understand how you change it. I was checking the code but I didn't find how to change TX0 output power.
I tried to change the line : abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_30mW); with abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_250mW); in the "create_objects" fonction but I don't know how the fonction is loaded, I don't know how the bs11 enter the state "BS11_STATE_WAIT_MIN_CFG_2"
you have to manually change the state into MAINTENANCE (by calling disconnect) and then call abis_nm_bs11_set_trx_power() -- - Harald Welte <laforge@gnumonks.org> http://laforge.gnumonks.org/ ============================================================================ "Privacy in residential applications is a desirable marketing option." (ETSI EN 300 175-7 Ch. A6)
Working fine thanks Eric Cathelinaud 2009/6/23 Harald Welte <laforge@gnumonks.org>
On Mon, Jun 22, 2009 at 03:22:50PM +0200, Eric Cathelinaud wrote:
Hi,
I was following your mails about your results for the ouput power but I don't understand how you change it. I was checking the code but I didn't find how to change TX0 output power.
I tried to change the line : abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_30mW); with abis_nm_bs11_set_trx_power(&bts->trx[0], BS11_TRX_POWER_GSM_250mW); in the "create_objects" fonction but I don't know how the fonction is loaded, I don't know how the bs11 enter the state "BS11_STATE_WAIT_MIN_CFG_2"
you have to manually change the state into MAINTENANCE (by calling disconnect) and then call abis_nm_bs11_set_trx_power()
-- - Harald Welte <laforge@gnumonks.org> http://laforge.gnumonks.org/
============================================================================ "Privacy in residential applications is a desirable marketing option." (ETSI EN 300 175-7 Ch. A6)
participants (2)
-
Eric Cathelinaud -
Harald Welte