understand that we only have to configure the Unit-id and Oml Address right
and I understand that the firmware is already installed .
I have tried the following :
ipaccess-config -f FIRMWARE -w
and sure it doesn't work :) .
And I also read the -w argument options that needs to be used to download
the firmware from BTS into debian system it should be used with -f .
Is it necessary to download it into our linux box or you need to configure
it only as it is already installed into BTS from ipaccess company .
Thanks,
Omar Atia
-----Original Message-----
From: openbsc-bounces(a)lists.osmocom.org
[mailto:openbsc-bounces@lists.osmocom.org] On Behalf Of Peter Hasse
Sent: Wednesday, January 19, 2011 12:14 PM
To: openbsc(a)lists.osmocom.org
Subject: Re: How to run openbsc on nanoBTS
On 19.01.2011 06:16, Ravi Shankar wrote:
Dear sir
Hi Ravi
I am new to openbsc.I have two NanoBTS(165cu).I'm facing some
difficulty which I'm summarizing below
I'm using Ubuntu10.04
1) Can we proceed with one nanobts.?
Yes, in fact i would recommend to start with
one and if you get familar
with openbsc you can add more bts.
2)I've configured bts ip,unit id, oml ip of one
bts.But not able to
get the firmware.
Check out ipaccess-config util from the openbts source. You can
download
the firmware out of the bts you have configured.
How to get it and configure for NanoBTS??
nanoBTS is a different project and based on the USRP. checkout
openbts.org to get further informations.
3)how to run openbsc ??
http://openbsc.osmocom.org/trac/wiki/BscHack
Please suggest the procedure to run the openbsc.
Thanks
mfg derPeter