24 Jun
2021
24 Jun
'21
1:03 p.m.
Hi Sylvain,
Thanks to your suggestions, I managed to decode the RACH from the captures
on L-band. I just had to tweak a few parameters in the graphs. I have
decoded the Paging Response and Location Update messages.
Do you have some suggestions on decoding the uplink speech? On the
downlink, the code follows the Immediate Assignment and decodes the traffic
channel. Due to the limitation of the SDR, I am not able to capture both
the downlink and uplink channels simultaneously.
Thank you again.
Best regards,
Johann
On Tue, May 25, 2021 at 7:26 PM Sylvain Munaut <246tnt(a)gmail.com> wrote:
Hi,
I have made some captures on the L-band uplink
channels and tried to
decode the RACH messages. All four consecutive TCH channels
(according to
the spot beam) were recorded and a call was made during the recording.
I am using the GRC block gmr_rach_scan.grc. I have removed the IQ swap
from the
graph, as suggested in the mailing list. The sampling rate and
samples-per-symbol values have been set to 93.6k and 4, respectively.
Oops, looks like I complete missed this ... sorry.
That graph was made to scan large bandwidth capture for RACH ... It's
very probable that a bunch of constants and thresholds value are just
not appropriate for a narrow band capture.
It kind of always required tweaking depending on the case. Basically
manually finding a RACH (in frequency and time), then look at all the
intermediate steps of the graphs (and possibly inside the block) to
see if it detects that particular one and tweak it until it does. And
then you can run it to find the other ones.
I don't have any setup any more to capture C-band uplink so I have not
run that graph in years .... but that's all I remember about it.
Cheers,
Sylvain