PCU sends invalid block number to L1

This is merely a historical archive of years 2008-2021, before the migration to mailman3.

A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/osmocom-net-gprs@lists.osmocom.org/.

Minh-Quang Nguyen minh-quang.nguyen at nutaq.com
Mon May 2 19:53:51 UTC 2016


Hi Holger,

The PDCH queue is directly connected to the PCU ( the PCU was compiled with direct L1 communication)


Minh-Quang Nguyen

Concepteur logiciel  |  Software designer GSM/Network


T. 418 914-7484 x2296  |  1 855 914-7484  |  F. 418 914-9477
2150, Cyrille-Duquet, Québec (Québec)  G1N 2G3 CANADA


minh-quang.nguyen at nutaq.com
www.nutaq.com 

 QUEBEC MONTREAL NEW YORK

Facebook Twitter LinkedIn YouTube


-----Original Message-----
From: Holger Freyther [mailto:holger at freyther.de] 
Sent: Monday, May 02, 2016 3:41 PM
To: Minh-Quang Nguyen
Cc: osmocom-net-gprs at lists.osmocom.org; Yves Godin
Subject: Re: PCU sends invalid block number to L1


> On 02 May 2016, at 15:32, Minh-Quang Nguyen <minh-quang.nguyen at nutaq.com> wrote:
> 
> Hi All,
>  
> We have noticed that the PCU sends invalid block number to L1 in DSP leading to unexpected message warning in DSP “GsmL1_PhDataReq(1) : Unexpected burst (Invalid blockNumber) [2!=1, SAPI 21-21]]”.
>  
> After an investigation, we observe that the ‘pcu_rx_rts_req’ function in pcu_l1_if.cpp receives invalid block number from BTS.
> Looking at the BTS side, the calculation of L1SAP_FN2PTCCHBLOCK defined as ‘#define L1SAP_FN2PTCCHBLOCK(fn) ((fn / 52) & 7)’ does not seem to be valid for expected PTCCH block numbers B0, B1,B2,B3 defined in Table 6 in TS 05.02 version 8.11.0.

How do you execute the PCU? By opening the PDCH queue directly or by getting all information from the BTS?

holger



More information about the osmocom-net-gprs mailing list