doesn't get output from osmocon

ml at ml at
Fri Jan 28 21:46:27 UTC 2011


first test if the cable is working. a fast but dirty way is to rub the
tip with your fingers. this generates noise that should show some random
input in osmocon.
also but sure to not charge the phone while using osmocon, this can
inhibit the ram loader.

good luck,

On 01/28/2011 08:09 PM, tobsen wrote:
> Hi,
> sorry if I shouldn`t write correclly, i`m not that good in english.
> i have a Motorola c118 and this usb/serial cable: 
> here 
> my problem:
> compiling was successfully.
> than i run osmocon:
> ./osmocon -p /dev/ttyUSB0 -m c123xor
> /home/test/install/osmocom-bb/src/target/firmware/board/compal_e88/layer1.ramload.bin
> i pressed power on the phone.
> nothing happend.
> again.
> nothing happend, no output, no upload/download to/from the phone...
> what is my fault? can you help me?
> i have tested it with:  -m 123 ; -m 118xor ; -m 118 (the same thing)
> my system is ubuntu 10.10 (not in a virtual box or something else).
> thanks a lot,
> tobsen

More information about the baseband-devel mailing list