This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Eric Cathelinaud e.cathelinaud at googlemail.comWell i tried every possibilities with the jumpers giving the same result: red steady at start and red blinking after bsc_hack. Following the jumper plan http://www.beronet.com/download/docs/BNXE1/BN1E1_Jumperplan.pdf I should normally have: C2 on the left (pin 1,2,4,5) C1 on the right (NT) D-1: 1-ON / 2-OFF So I came back on my first jumper configuration. I checked also the RJ45 link on my BTS - Y01 PCM in (from BSC): RJ45 pin 4,5 - Y02 PCM out (to BSC): RJ45 pin 1,2 which is Y01 : blue/white blue and Y02 : orange/white orange for a straight cable I noticed something else but don't know if will help: After reboot, when launching bsc_hack for the first time, the protocol is 0 and, when launching bsc_hack after, it's everytimes equal to 4. Best regards Eric Cathelinaud 2009/5/25 Eric Cathelinaud <e.cathelinaud at googlemail.com> > I just noticed something more: the red led are steady at reboot and when > configuring bs11 (bs11_config) and when I launch the bsc_hack, the led start > to blink. > I followed the jumperplan from Beronet but I think there is something wrong > cause if the card I can see on the following link is also a BN1E1 I don t > have the same locations. > > http://bs11-abis.gnumonks.org/trac/attachment/wiki/HFC-E1/hfc_e1_evalbd_jumper.jpg > I will try this one and let u know > > 2009/5/25 Eric Cathelinaud <e.cathelinaud at googlemail.com> > > I have this in the /boot/grub/menu.lst and it doesn't display any error at >> restart. >> >> title Debian GNU/Linux, kernel 2.6.27.4 >> root (hd0,0) >> kernel /boot/vmlinuz-2.6.27.4 root=/dev/hda1 hfcmulti.dslot=1 ro >> quiet >> initrd /boot/initrd.img-2.6.27.4 >> >> >> 2009/5/25 Andreas.Eversberg <Andreas.Eversberg at versatel.de> >> >> did you load hfcmulti.ko with dslot=1 parameter? this is required to >>> move dchannel slot from 16 to 1. >>> >>> >>> > Mon May 25 16:07:39 2009 <1000> input/misdn.c:125 alen =6, dev(0) >>> channel(0) sapi(63) tei(127) >>> > Mon May 25 16:07:39 2009 <1000> input/misdn.c:128 <= len = 12, >>> prim(0x8) id(0x7f3f): DL_INFORMATION_IND >>> > Mon May 25 16:07:39 2009 <1000> input/misdn.c:135 DL_INFORMATION_IND: >>> use channel(0) sapi(63) tei(127) for now >>> > ISDN message for unknown sign_link >>> > >>> >>> >> > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.osmocom.org/pipermail/openbsc/attachments/20090525/b94a7b58/attachment.htm>