This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Holger Adams holger at kernreaktor.orgHello Bjoern, Am Di, 5.05.2009, 08:59, schrieb Bjoern Heller: > So, > > here is the console dump: > > ... > Tue May 5 10:53:02 2009 <0020> abis_nm.c:1483 CONNECT TERR TRAF > Um=(bts=0,trx=0,ts=6) E1=(0,3,2) > Tue May 5 10:53:02 2009 <0020> abis_nm.c:1544 Set Chan Attr > (bts=0,trx=0,ts=7) > Tue May 5 10:53:02 2009 <0020> abis_nm.c:1483 CONNECT TERR TRAF > Um=(bts=0,trx=0,ts=7) E1=(0,3,3) > bootstrapping RSL for BTS/TRX (0/0) using MCC=602 MNC=1 > Tue May 5 10:53:35 2009 <0020> abis_nm.c:674 OC=UNKNOWN(a4) > INST=(00,ff,ff) Failure Event Report > Tue May 5 10:53:35 2009 <0020> abis_nm.c:674 OC=UNKNOWN(a4) > INST=(00,ff,ff) STATE CHG: > > > The net wont become visible. > Maybe it is related to this line? > > Tue May 5 10:53:02 2009 <0020> abis_nm.c:674 OC=RADIO CARRIER(02) > INST=(00,00,ff) STATE CHG: OP_STATE=Disabled AVAIL=In test(00) Everythings looks fine. You have to wait up to 15 minutes until you can select the network w/ your mobile phone. There's also a frequency stability problem (see the last dozen of posts here) which occours with the HFC-E1 card. With the current OpenBSC version you can switch the frequency reference to the internal quartz. We (Faculty of Com. Eng.) are building a GPS/DCF77 disciplined quartz reference for the HFC-E1 card at the moment where we hopefully get the required ~0.01PPM precision. Maybe it's finished until the 26c3. Some mobile phones are also very choosy, just try another one. Best Regards, Holger -- | Holger Adams <holger at kernreaktor.org> | University of Applied Sciences Esslingen | Faculty of Communications Engineering