This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Michael Gernoth michael.gernoth at informatik.uni-erlangen.deOn Wed, Mar 04, 2009 at 02:15:29PM +0100, Klaus-Peter Junghanns wrote: > I followed the steps in the wiki, e.g. run "bs11_config -p /dev/ttyS0" > and then turn on the BS-11. The green power LED on the BS-11 is solid > green. But i do not get any output from the bs11_config (e.g. no > booting messages, etc). :-( You should start bs11_config after turning on the BS-11, as it tries to login to the BS-11 as the first step. I usually start the BS-11, wait 2 minutes and then start bs11_config. > Sometimes bs11_config segfaults when i switch on the power to the BS-11: Because it receives the initial spikes on the serial line as "garbage" and tries to interpret them. Just don't do it in this order. > The serial cable is connected to the serial port (1 of 4) which is > closest to the antenna connectors (like i have seen it on the photo). That is the right connector. If the communication does not work when you start bs11_config after the BS-11, try a serial to usb adapter. I had no success with the normal serial ports on two different machines, but a (FTDI) serial converter worked at once. See also: http://bs11-abis.gnumonks.org/trac/wiki/BS11_Troubleshooting Regards, Michael -- Michael Gernoth Department of Computer Science IV Martensstrasse 1 D-91058 Erlangen Germany University of Erlangen-Nuremberg http://www4.informatik.uni-erlangen.de/~gernoth/