This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Sergey V. Efimov se at connecto.tvI've downloaded the firmware to the BS-11 station. The problem persists. I observe load on MBCCU0, PHASE: 3 Normal and Abis-link: UP, but bsc_hack still reports "Lost some TEI E1 Link". No network. On Aug 7, 2009, at 8:41 PM, dexter wrote: > Hi! > > I had a very semilar problem! >> Specifically, it seems the SMU Safety load is installed and the >> minimal >> configuration exists, but no actual Software is installed. Thus, >> the MBCCU0 and MBCCU1 remains in "No Load", i.e. no firmware running. >> > MBCCU0 and MBCCU1 will also remain in "No Load" when the oml objects > are not created correctly. If the firmware is missing the power lamp > lights up red. If it remains green the firmware should be ok - i > think. > > To verify if it is a problem with the oml objects you can activate > the second trx with create-trx1. If MBCCU1 loads on the next startup > it must be a problem with the initial, minimal configuration. > > regards > Philipp