Matt Ames email@example.com [op25-dev]
op25-dev at yahoogroups.com
Sun Feb 7 22:50:24 UTC 2016
Tell me this - what frequency did you tell it to tune to using the command
Does the line that says "[R820T] PLL not locked for 3570434 Hz!" give you
any hints as to what may have gone wrong?
As has been suggested, check out the command line arguments before running
On 8 February 2016 at 09:25, Sean Kealy superstardodge at yahoo.com [op25-dev]
<op25-dev at yahoogroups.com> wrote:
> When I open waterfall i get the following pasted below in terminal, and
> the waterfall doesnt do anything, do I have to open grc in terminal first
> root at kali:~# ./op25_grc.py
> Using Volk machine: sse3_64_orc
> RTL2832 Source block configuration:
> Read length (bytes): 262
> Buffer enabled: yes
> Buffer multiplier: 8
> Buffer size (samples): 1048
> Samples per read: 131
> Buffer level: 50.0%
> Successfully initialised demod: "ezcap EzTV"
> Probing "e4k"...not found.
> Probing "fc0013"...not found.
> Probing "fc2580"...bad check value.
> Probing "r820t"...found.
> Found RTL2832 device: ezcap EzTV (tuner: Rafael Micro R820T)
> Sample rate range: 900001 - 3200000 Hz
> Crystal frequency: 28800000 Hz
> [r820t] Initialised (default bandwidth: 0 Hz)
> Wait delay: 0.196 ms
> [R820T] PLL not locked for 3570434 Hz!
> work wants more than the buffer size!
> Capture threading starting: 7f904e7fc700
> rOShort bulk read: given 0 bytes (expecting 262)
> rBlibusb error: the device has been disconnected [-4]
> Capture threading aborting due to libusb error: 7f904e7fc700
> No longer running after packet notification - signalling EOF...
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the op25-dev