This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/baseband-devel@lists.osmocom.org/.
Steve Markgraf Steve.Markgraf at student.hs-rm.deHi Kevin, On 07.07.2012 11:15, Kevin Redon wrote: > - the additional volume up/down and camera buttons press are detected > by keypad_poll(), but not visible in KBR_LATCH_REG Yes, for that you need to increase the number of rows/columns that are scanned (can exactly remember which one). The Compal phones don't use all of them. > - the power button press is not detected by keypad_poll() (or ignored > by > "with_interrupts && !polling") As it seems the power button is not connected to the keyboard scan matrix. You get an interrupt from Iota though when the button is pressed, see [2]. That code was removed again from master. > - the keypad.h file is in target/firmware/include/, but it's board > dependent. is there a clean way to handle that? Did you check out the steve-m/pirelli branch [2]? It already contains the modified keypad header. Those changes should definitely be cleaned up and put into master, especially make the UARTs runtime configurable to have them swapped for the DP-L10. Regards, Steve [1] http://cgit.osmocom.org/cgit/osmocom-bb/commit/?id=4f0825a352af5499beee068dedbd5e9cf5674262 [2] http://cgit.osmocom.org/cgit/osmocom-bb/commit/?h=steve-m/pirelli