This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/linux-dect@lists.osmocom.org/.
Patrick McHardy kaber at trash.netAm 01.11.2010 11:51, schrieb NoOne: > > Hi ... I successfully ran asterisk with a cluster in FP mode with one handset. > Now I tried to use asterisk acting as a PP so that it can accept calls from PSTN. > > I catched EMC and FPN of my base station via dect-llme-scan. > Where do I pass the PIN code for access_rights_requests? > > When I want to start asterisk I get following error messages: > > > netlink: cu: mode PP ARI: class A: EMC: 0d13 FPN: 126f4 > netlink: FPC: full_slot,page_repetition,basic_a_field_setup,in_min_delay > netlink: HLC: adpcm_g721_voice,gap_pap_basic_speech,standard_authentication,location_registration > LCE: set default pmid e16c8 > LCE: registered protocol 0 (Link Control) > LCE: registered protocol 3 (Call Control) > LCE: registered protocol 4 (Call Independant Supplementary Services) > LCE: registered protocol 6 (ConnectionLess Message Service) > LCE: registered protocol 5 (Mobility Management) > > netlink: MAC_ME_RFP_PRELOAD-req > netlink: HLC: adpcm_g721_voice,gap_pap_basic_speech,standard_authentication,standard_ciphering,location_registration,ciss_service,clms_service,list_access_features > [Nov 1 11:44:09] ERROR[3477]: chan_dect.c:2338 dect_load_module: Unable to set FP capabilities > == Unregistered channel type 'DECT' Running asterisk in PP mode is currently not supported.