This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/simtrace@lists.osmocom.org/.
Kevin Redon ml at mail.tsaitgaist.infoExcerpts from Harald Welte's message of 2013-07-21 10:25:11 +0200: > > Please note that (as opposed to the regular mini-SIM) we only have one > of the possible four orientations available. This is primarily due to > the high manufacturing cost of low-volume flexible PCB projects. I used the adapter several times now. This direction (cable coming out of the cornered side) works most of the time with phone which have a tray. But with phone which have a push-push slot (like the galaxy s3), the cable should be on the other side. So ideally cables with opposing directions should be available. But bending the cable over the card works just fine. > > On a related note: For nanoSIM, I think we would have to go for > dual-layer PCB with vias placed inside the actual card contact pads. > This will make production cost even more expensive than the microSIM > adapter. So unless there's significant interest in a nanoSIM adapter, > it's unlikely that we'd have some made. Please let us know if you > absolutely want one, and if you're happy to pay even more (e.g. 25-30 > EUR) for only that adapter. for nanoSIM (and microSIM), I've discovered these tools. cutting the right lines would make cables out of it, else you can use it as is, but the traffic goes through the mitm chip. https://dx.com/p/dual-sim-card-adapter-converter-for-iphone-5-177356 https://dx.com/p/dual-sim-card-adapter-for-iphone-4-47228 tsaitgaist