This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/osmocom-sdr@lists.osmocom.org/.
Torben Keil keil at keil-tech.deHi Steve, do you have a git repository for the code so that I could have a try? Regards, Torben Am 11.06.2018 22:57, schrieb Steve Markgraf: > Hi Torben, > > On 11.06.2018 22:15, Torben Keil wrote: >> I tried to get a signal over the i2c interface but it wasn't >> sucsessful. >> Do you have an idea how to enable the i2c interface on the fl2k chip? > > I have some code sitting here, but when I wanted to clean it up > recently, it didn't work anymore as expected. I'll need to debug it > with > a logic analyzer. Note that the FL2000 can only do I2C transfers of a > fixed length of 4 bytes, it was probably really only meant to read EDID > EEPROMs. > In the original driver, single register writes to the ITE HDMI > interface > chip that some devices have are first reading 4 registers, then > modifying the desired byte, and then writing them back. > > Regards, > Steve