This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Erich Dachleger edachleger at yahoo.comHi all, I have followed the the guide in network_from_scratch and use 1 osmocom phone as transceiver. I use the suggested configs for open-bsc.cfg and osmo-bts.cfg and can register to the network I run. However in the output from osmo--nitb ,in the start I get a message about the training sequence: ________________________________________________ % This BTS does not support a TSC!=BCC, Falling back to BCC and after the DB: Database initialized messages DB: Database prepared ---------------------------------- -------------------------------- <0005>bsc.init.c:265 bootstrapping RSL for BTS/TRX(0/0) on ARFCN 533 using MCC=1 MNC=1 LAC=1 CID=0 BSIC=63 TSC 7 ------------------------------------------ <0002> gsm.subscriber.c: 378 Subscriber <imsi> ATTACHED LAC=1 ----------------------------------------------------------------------------------------------------- I have entered hlr.sqlite and assigned an extension to my imsi but when I enter the VTY and execute enable subscriber imsi <imsi> sms send test123 I get: %Unknown command So it appears smsqueue is not enabled. Does anyone know what to look for to enable it? I have tried the vty commands trigger smsqueue but to no avail.. According to the network from scratch wiki sms (and broadcast) should function with one phone where TS0 is served ------------------------------------------------------------------- osmo-bts-trx outputs lines of <0006> scheduler.c 338 ---- chan=SDCC/4(0) --- chan=SACC/4(0) ----- chan=BCCH(0) ---------------------------------------------------------------------------------------------------------- When the firmware is loaded onto the phone I get time on arrival and signal to noise ratio messages: TOA=4 snr=16384 (Thres 2560) freq_err=40 pm=-70 -------------------------------------------------------- So that is grossly exceeding the threshold value. But is that related to not being able to use smsqueue? Regards Erich -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.osmocom.org/pipermail/openbsc/attachments/20140624/2b53240e/attachment.htm>