This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Tom Tsou tom at tsou.ccOn Thu, Jan 30, 2014 at 2:31 AM, Andreas Eversberg <andreas at eversberg.eu> wrote: > in case of TRX 0, osmo-bts always sends bursts, even on idle bursts. it > sends dummy bursts in this case. i suggest that there is no RF power in case > of TRX>0 for each single burst, that is not sent from osmo-bts. the reasons > are: > > - one TCH/H channel of one TS may be in use, so the other channel should be > disabled, to reduce noise on the spectrum. > - DRX (in the future) might be used to reduce noise on the spectrum. > - SACCH is disabled when leaving dedicated mode, so the MS runs into radio > link timeout, if the release message does not go through or some error > occurs. > > i think about three solutions to make make osmo-trx send no RF power per > burst: > > 1. omso-bts does not send any burst to osmo-trx Please try out the filler branch I posted earlier. It does exactly that. -TT