Unable to configure a BTS

This is merely a historical archive of years 2008-2021, before the migration to mailman3.

A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.

Nordin bouchtaoui at gmail.com
Fri Jul 23 11:15:32 UTC 2010


Than you haven't shortcutted the two pins well, cause if you did, after 
30 seconds it flashes red light.
I had that in the first time too, until I found a way to shortcut it 
well. I used a screwdriver, just try it again, it should work. Don't 
worry, it won't damage a lot :p


On 23-7-2010 13:09, Luca Bertoncello wrote:
> Am Fri, 23 Jul 2010 13:03:53 +0200
> schrieb Nordin<bouchtaoui at gmail.com>:
>
>    
>>> Now I found the connector you mean. It's like a RJ45, but with 10
>>> pins. Isn't it?
>>>
>>> Now which are the PINs 9 and 10? The last two LEFT or the last two
>>> RIGHT?
>>>
>>> Thanks!
>>>
>>>        
>> -----------------------------
>> |    U U U U U U U U U U    |
>> |                    | |    |
>> |    0 ..            9 10   |
>> |                           |
>> |                           |
>> |___________     ___________|
>>                               |_____|
>>
>> I hope this helps :)
>>      
> Unfortunately not...
>
> I tried to short PIN9+10, and wait until the LED flashes (more than 2
> mins), then I powered off and on the BTS.
>
> It does not seems it was resetted...
>
> Other suggestions?
>    





More information about the OpenBSC mailing list