This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/OpenBSC@lists.osmocom.org/.
Nordin bouchtaoui at gmail.comThanks for your responses guys, It was my mistake I wrote "auth_policy" instead of "auth policy" Bjoern Heller schreef: > Try to telnet to localhost 4242 > > then > > enable > configure terminal > network > auth policy accept-all > > > Best Regards > Björn Heller > > Am 09.11.2009 um 12:40 schrieb Nordin <bouchtaoui at gmail.com>: > >> Thank you for your response, >> >> 246tnt at gmail.com schreef: >>> Hi, >>> >>>> If I run the latest version of openbsc and tried to register with >>>> my MS (Nokia 6310) to it, my phone finally says No Access. >>> >>> Because the IMSI is probably not an authorized one. >> >> Uhhh, where can I authorize it? >> >>>> I just use the standard config file for nanobts and changed a few >>>> parameters like unit_id, band, mcc and mnc, that's all. I noticed >>>> that I can't add an accept parameter, like before. Also in the >>>> config file I can't find anything like that, am I missing something? >>> >>> The equivalent config parameter is "auth policy". The defaut nano >>> bts config file uses "auth policy closed" so all unauthorized phones >>> will be rejected. You need t use "auth policy accept-all" if you >>> want to authorized everyone without any check. >>> >> >> I don't want to bother you with silly questions, but I just can't >> find something about policy in the config-file examples, see link. >> http://repo.or.cz/w/openbsc.git/blob_plain/HEAD:/openbsc/src/openbsc.cfg.nanobts >> >> >> >> >