First of all, thank you very much for being so busy and being able to reply to my question of being so mentally challenged. Haha

I have tested and found that there may have been some issues with my PCB production, and I have also identified the cause. As shown in Figure 1,

Through this flywire, I successfully flushed in the required firmware program. Both lights are on, which makes me very excited.

I linked the firmware and installed the dfu driver under Windows, but the result showed this

I have tried several dfu drivers, and there is a yellow exclamation mark below this icon!

At this point, I saw that there was a simtrace in the USB device on my vmbox. I don't know if this is considered a success. I can only continue to try.

Can find the current device.

I entered the osmo remsim client st2 command according to the user manual

I have carefully read the manual, but I am still confused as to which part I should start with. Can you give me a simple idea? Do I first set up the card reader section, then the server section, and finally the simtrace2 section?

从 Windows 版邮件发送