The wiki page has the firmware attached in the format required by SAM-BA. I compiled it myself with the arm toolchain, though. The tricky part was switching to SAM-BA mode, what the wiki page says is true: sometimes it just not works ... After 3 or 4 attempts it worked.
I hope this helps.
Regards.
2016-10-16 22:28 GMT+02:00 Holger Freyther <
holger@freyther.de>:
>
>
> > On 16 Oct 2016, at 22:15, Michael Kramer <
michael.kramer@uni-konstanz.de> wrote:
> >
> >
> > Am Freitag, 14. Oktober 2016 22:19 CEST, Holger Freyther <
holger@freyther.de> schrieb:
> >
> >>>
> >>> I've tried both dfu-utils 0.8 and 0.9 on a debian and kali machine. Haven't used SAM-BA yet. Should I try that as well?
> >>
> >> SAM-BA is a lot more inconvenient and slower than dfu-utils. Could you try an older version of dfu-utils? E.g. I started with dfu-utils and probably still have this version around.
> >
> > Could you maybe check which version it was?
>
> oh. I did and then didn't write it down. It was dfu-util 0.4 that I have used in
> the past.
>
> holger
--
J. Félix Ontañón
Director of R&D
Podsystem Group