Hello,
Now I can configure the bs11 using the bs11_config. Everything worked fine and I obtained this on bs11_config query :
LMT LOGON: ACK
PHASE: 3 Normal MBCCU0: Load MBCCU1: No Load Abis-link: Restoring
BS11 ATTRIBUTES:
BS-11 ESN PCB Serial Number: 001073
BS-11 ESN Hardware Code Number: 135-2044/03.03
BS-11 ESN Firmware Code Number: 135-2044/03.03
PLL Set Value=1053, Work Value=1053
SITE MANAGER ATTRIBUTES:
E1 Channel: Port=0 Timeslot=1 (Full Slot)
TEI: 25
BS11 Line Interface ATTRIBUTES:
PLL Mode: Standalone
BS11 Power Amplifier 0 ATTRIBUTES:
TRX Power: 30mW (GSM)
Mon May 25 16:01:12 2009 <0020> abis_nm.c:811 GET ATTRIBUTE NACK
LMT LOGOFF: ACK
I didn't doanwload:
-the SAFETY LOAD software
-the BTS software
Is it necessary since I can reach Phase 3 and since I can see the Firmware Code Number?
I continued to follow the "getting started" tutorial untill the E1 Link and I have the following problem when launching bsc_hack :
./bsc_hack -f 123 --debug=DRLL:DCC:DMM:DRR:DRSL:DNM:DMI:DMUX:DPAG:DRLL:DSMS
DB: Database initialized.
DB: Database prepared.
1 device found
id: 0
Dprotocols: 00000018
Bprotocols: 0000006e
protocol: 4
nrbchan: 30
name: hfc-e1.1
activate bchan
activate bchan
Mon May 25 16:07:39 2009 <1000> input/misdn.c:125 alen =6, dev(0) channel(0) sapi(63) tei(127)
Mon May 25 16:07:39 2009 <1000> input/misdn.c:128 <= len = 12, prim(0x8) id(0x7f3f): DL_INFORMATION_IND
Mon May 25 16:07:39 2009 <1000> input/misdn.c:135 DL_INFORMATION_IND: use channel(0) sapi(63) tei(127) for now
mISDN message for unknown sign_link
May be it's coming from my BN1E1 card from Beronet. I only changed the Dip switches for 120 ohms.
I can see 2 steady red led (which means i am in NT mode, TE mode deactivate). Both green leds are off (is it normal?).
/* HFC-E1 OEM */
+ /* 2 red blinking: NT mode deactivate
+ * 2 red steady: TE mode deactivate
+ * left green: L1 active
+ * left red: frame sync, but no L1
+ * right green: L2 active
+ */
Anyone?
Thanks in advance!
Best regards
Eric Cathelinaud