Hello Dieter,

I tried it several times,
and left the BTS on over night.
The LMT cable wasn't always plugged in.
When I boot up the BTS it always says that the second TRX
has Load and the first not.
If I try to bring up the BTS with your SW under Win.
I get the Abis Link Up but when I try the Load DB I get some
error messages on LMT.
Then the second TRX goes down to No Load.
And this is the condition until I reboot the BTS.
Maybe its a software issue?

Best regards
Björn


Am 23.04.2009 um 08:19 schrieb Dieter Spaar:

Hello Bjoern,

I finally got time to try out my BTS.
When I looked at the LMT I was confused about the
"MBCCU0: No Load" which seems to be the TRX0 ?

Probably this is a similar problem I have with my BS-11, when
turning on the cold BS-11 the first time, frequently the firmware
load for TRX0 fails. Most certainly this comes from a hardware
problem (maybe aged capacitors ?).

I have to restart (turn off and on) the BS-11 a few times till it
works. If the unit has warmed up, I never saw this problem till now.

I also made the experience that it could help if no LMT cable (serial
cable) is attached so I usually try it this way: Turn the BS-11 on
without the LMT cable plugged in (at the BS-11 side) and after a
while (around 5 to 10 minutes) check if the firmware for TRX0 is
loading or is already loaded. If it fails, unplug the LMT cable,
turn the BS-11 off and try again. I am not really sure about the
effect of the LMT cable, but maybe the cable receives noise.

Best regards,
 Dieter
--
Dieter Spaar, Germany                           spaar@mirider.augusta.de


- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Björn Heller