Sorry, entering the command lne arguments and parameters is where im struggling, what could I enter for a command if I wanted to listen to 139.5600?

--------------------------------------------
On Sun, 2/7/16, Matt Ames matt.ames7bc@gmail.com [op25-dev] <op25-dev@yahoogroups.com> wrote:

Subject: Re: [op25-dev] waterfall
To: op25-dev@yahoogroups.com
Received: Sunday, February 7, 2016, 2:50 PM

Tell me this - what
frequency did you tell it to tune to using the command
line arguments?

Does the line that says "[R820T] PLL not
locked for 3570434 Hz!" give you
any
hints as to what may have gone wrong?

As has been suggested, check out the command
line arguments before running
the
program.





On 8 February 2016 at 09:25, Sean Kealy superstardodge@yahoo.com
[op25-dev]
<op25-dev@yahoogroups.com>
wrote:

>
>
> When I open waterfall
i get the following pasted below in terminal, and
> the waterfall doesnt do anything, do I
have to open grc in terminal first
>
somehow?
> thanks
>
sean
>
> root@kali:~#
./op25_grc.py
> Using Volk machine:
sse3_64_orc
> RTL2832 Source block
configuration:
>     Read
length (bytes): 262
> 
   Buffer enabled: yes
> 
   Buffer multiplier: 8
> 
   Buffer size (samples): 1048
>     Samples per read: 131
>     Buffer level: 50.0%
> Successfully initialised demod:
"ezcap EzTV"
> Probing
"e4k"...not found.
> Probing
"fc0013"...not found.
> Probing
"fc2580"...bad check value.
>
Probing "r820t"...found.
>
Found RTL2832 device: ezcap EzTV (tuner: Rafael Micro
R820T)
>     Sample rate
range:    900001 - 3200000 Hz
> 
   Crystal frequency:    28800000 Hz
> [r820t] Initialised (default bandwidth: 0
Hz)
> Wait delay: 0.196 ms
> [R820T] PLL not locked for 3570434 Hz!
> work wants more than the buffer size!
> Capture threading starting:
7f904e7fc700
> rOShort bulk read: given 0
bytes (expecting 262)
> rBlibusb error:
the device has been disconnected [-4]
>
Capture threading aborting due to libusb error:
7f904e7fc700
> No longer running after
packet notification - signalling EOF...
>
>
>
>
>

• New Members 1