Attention is currently required from: laforge, pespin, msuraev.
8 comments:
File common/chapters/cs7-config.adoc:
Patch Set #1, Line 349: Osmocom SS7 supports dynamic routing, allowing minimal SS7 configuration. If all of your components support dynamic
I'd do a s/dynamic routing/dynamic routing key management/ all over the text. […]
Done
Patch Set #1, Line 373: - its own point-code -- has to match the PC in osmo-stp.cfg
Perhaps better: "has to match its own PC entry in osmo-stp. […]
Done
Patch Set #1, Line 376: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-stp.cfg
IP:ports -> IP:port?
it's remote and local, two ports...
Patch Set #1, Line 382: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-stp.cfg
IP:ports -> IP:port?
Done
Patch Set #1, Line 387: - all point-codes -- they have to match the PC in osmo-bsc.cfg and osmo-msc.cfg
You list first point codes and afterwards routing keys in the MSC and BSC section. […]
Done
Patch Set #1, Line 388: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-bsc.cfg and osmo-msc.cfg
IP:ports -> IP:port?
Done
Patch Set #1, Line 454: ty synchronize point-codes and routing keys between STP and \{BSC,MSC}:
typo: to
Done
Patch Set #1, Line 454: synchronize
I would replace synchronize with "manually configure", as "synchronize" might refer to some kind of […]
Done
To view, visit change 32273. To unsubscribe, or for help writing mail filters, visit settings.