Attention is currently required from: neels.

View Change

7 comments:

• File common/chapters/cs7-config.adoc:

  • Patch Set #1, Line 349: Osmocom SS7 supports dynamic routing, allowing minimal SS7 configuration. If all of your components support dynamic

    dynamic routing through Routing Key Management (RKM)

  • Patch Set #1, Line 373: - its own point-code -- has to match the PC in osmo-stp.cfg

    Perhaps better: "has to match its own PC entry in osmo-stp.cfg"

  • Patch Set #1, Line 376: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-stp.cfg

    IP:ports -> IP:port?

  • Patch Set #1, Line 382: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-stp.cfg

    IP:ports -> IP:port?

  • Patch Set #1, Line 387: - all point-codes -- they have to match the PC in osmo-bsc.cfg and osmo-msc.cfg

    You list first point codes and afterwards routing keys in the MSC and BSC section. Makes sense to have same order here too.

  • Patch Set #1, Line 388: - local+remote IP:port for M3UA -- have to match the IP:ports in osmo-bsc.cfg and osmo-msc.cfg

    IP:ports -> IP:port?

  • Patch Set #1, Line 390: .osmo-bsc.cfg

    I think it makes more sense to move each of these below the bullet list of each component above. This way you can check each bullet with the config file by the side.

To view, visit change 32273. To unsubscribe, or for help writing mail filters, visit settings.