Hi all.<div><br></div><div>I have question about preselector improving:</div><div>Do we need on-board eeprom for identification?</div><div>It also can contain band andšIF freq values, T'C look-up table foršSAW, etc.</div>
<div><br></div><div>Best regards,<div>Andrey Sviyazov.</div><br>
<br><br><div class="gmail_quote">2012/8/9 Andrey Sviyazov <span dir="ltr"><<a href="mailto:andreysviyaz@gmail.com" target="_blank">andreysviyaz@gmail.com</a>></span><br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
<p><br>
08.08.2012 22:46 ÐÏÌØÚÏ×ÁÔÅÌØ "Sylvain Munaut" <<a href="mailto:246tnt@gmail.com" target="_blank">246tnt@gmail.com</a>> ÎÁÐÉÓÁÌ:</p><div><div class="h5"><br>
><br>
> Hi,<br>
><br>
> > Its about far-near problem (05.05 p.5.1), i.e. blocking by near mobile with<br>
> > high signal at only 600kHz offset.<br>
> > Therefore, calculated that LO noise at 600kHz offset should be around<br>
> > -140dBc/Hz to keep nominal Rx sencitivity for wanted far mobile.<br>
><br>
> Mmm, interesting, I had never thought about this.<br>
><br>
> Can you confirm my computation is the right one :<br>
><br>
> Minimum Ec/No of 8 dB, thernal noise of GSM ~ -120 dBm, so the weakest<br>
> mobile would be a -112 dBm.<br>
><br>
> The interference I see specified in 05.05 is a -26 dBm sine, so with<br>
> -140 dBc/Hz you'd get a -166 dBm 'leak' of the interference in the<br>
> signal of interest at any given position, which you need to integrate<br>
> over the entire useful bandwidth of the GSM signal ( 271 kHz -> 10 *<br>
> log10(271e3) = 54 dB ), which would give a -112 dBm noise.<br>
><br>
> Cheers,<br>
><br>
> š š Sylvain<br></div></div>
Yes, your computation confirm that we can getš noise flour -109 dBm in summary.<br>
But I can't understand this stupid requirement.<br>
Really blocker it is mobile signal, therefore it will make direct jumming due to GMSK spectrum mask.<br>
What do you think about it?<p></p><div class="HOEnZb"><div class="h5">
<p>Best regards,<br>
Andrey Sviyazov.<br>
(Sent from my mobile client)</p>
</div></div></blockquote></div><br></div>