The Difference of Signal Strength From Two Channels on The Same Board is Big

Alexander Chemeris alexander.chemeris at
Fri Aug 2 08:20:16 UTC 2013

Hi Jiang,

Are you sure you're setting Rx gain properly for both channels?
I recommend you to use script from this repository to
check Rx LNA and Rx VGA settings for both LMS chips:

On Fri, Aug 2, 2013 at 12:09 PM, jiangwy <wyjiang at> wrote:
> Hi Alexander Chemeris,
> According to rx_multi_samples , I write a program to receive samples from
> two channels on the same board.
> The program receive samples from 2 channels and calculate the signal
> strength respectively. The signal is from a BTS arround.
> I find the difference of signal strength is very big, about 20dB, and
> channel 1 is bigger than channel 0.
> I  exchange the antenna and feeder of the them, but the result is same.
> I think there is some problem, but I cann't find it.
> Would you please give me some sugguestion?
> Best Regards.
> ________________________________
> Jiang Wenyi

Alexander Chemeris.
CEO, Fairwaves LLC / ООО УмРадио

More information about the UmTRX mailing list