This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/UmTRX@lists.osmocom.org/.
Gillian Seed gillian.seed at outlook.comHi, I'm having a problem while trying to do a LPF Bandwidth tuning as described in a Programming and Calibration guide page 40, figure 4.5 and on https://github.com/chemeris/UHD-Fairwaves/blob/fairwaves/umtrx/host/utils/umtrx_lms.py#L433. Currently it seems to always fail when it's trying to find the VCOCAP value. I'm only getting Low printed before it fails. I was wondering why it takes a 320MHz frequency, because it's not described anywhere in the documents, could I try to do a bandwidth tuning with some other frequency as well? I'm running my code in a following order (http://lists.osmocom.org/pipermail/umtrx/2012-July/000075.html), Example setup for ARFCN 925: Initialization and auto-calibration: ./umtrx_lms.py --lms 1 --lms-init ./umtrx_lms.py --lms 1 --lms-tx-enable 1 ./umtrx_lms.py --lms 1 --lms-rx-enable 1 ./umtrx_lms.py --lms 1 --pll-ref-clock 26e6 --lpf-bandwidth-code 0x0f --lms-auto-calibration RX LNA and RXVGA2 selection and gain control ./umtrx_lms.py --lms 1 --reg 0x75 --data 0xf0 ./umtrx_lms.py --lms 1 --reg 0x65 --data 10 TX LPF control ./umtrx_lms.py --lms 1 --reg 0x34 --data 0x3e LO leakage cancellation (calibration data values may vary) ./umtrx_lms.py --lms 1 --reg 0x42 --data 0x67 ./umtrx_lms.py --lms 1 --reg 0x43 --data 0x89 TX/RX PLL charge pump current ./umtrx_lms.py --lms 1 --reg 0x16 --data 0x93 Tuning ./umtrx_lms.py --lms 1 --lms-rx-pll-tune 925.2e6 ./umtrx_lms.py --lms 1 --lms-tx-pll-tune 880.2e6 TXVGA2 gain to max and enable PA ./umtrx_lms.py --lms 1 --reg 0x45 --data 0xc8 ./umtrx_lms.py --lms 1 --lms-pa-on 2 -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.osmocom.org/pipermail/umtrx/attachments/20121008/2fc768a2/attachment.htm>