<div dir="ltr">Thanks, I'll check it out. <br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Thu, Oct 3, 2019 at 3:42 PM Diego Leñero <<a href="mailto:dielenram@gmail.com">dielenram@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">Hi,<div><br></div><div>I experienced the same problem and Kevin Redon solved it. As per his words "The only cause I could find is an accidental short between the ERASE and nearby 3.3V pin (on top of the board)." And he was right. He documented the solution:</div><div>1st reflash the DFU bootloader</div><div><a href="https://osmocom.org/projects/simtrace2/wiki/Flashing#SAM-BA" target="_blank">https://osmocom.org/projects/simtrace2/wiki/Flashing#SAM-BA</a><br></div><div><br></div><div>2nd flash the application firmware</div><div><a href="https://osmocom.org/projects/simtrace2/wiki/Flashing#DFU" target="_blank">https://osmocom.org/projects/simtrace2/wiki/Flashing#DFU</a><br></div><div><br></div><div>I hope this helps,</div><div>Diego.</div><div><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">El jue., 3 oct. 2019 a las 21:25, super sad (<<a href="mailto:supersupersadguy23@gmail.com" target="_blank">supersupersadguy23@gmail.com</a>>) escribió:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">Hello,<div><br></div><div>We have simtrace v2. When we connect the device through USB to a laptop it does not respond. None of the lights turn on. It does not respond to any commands. ./simtrace2-lists shows Device = 0.</div><div><br></div><div>Can you give us some suggestions on how to use the device and if this is the normal behavior?</div><div><br></div><div>Thank you for your time. </div></div>
</blockquote></div>
</blockquote></div>