<div dir="ltr">Hi Michael,<br><br>Just to let you know dfu-util 0.9 didn't worked for me either, but SAM-BA/sam7utils did! <div><br></div><div>I just followed this simtrace wiki page instructions to do so (flashing using libusb): <a href="https://osmocom.org/projects/simtrace/wiki/SIMtrace_Firmware">https://osmocom.org/projects/simtrace/wiki/SIMtrace_Firmware</a></div><div>The wiki page has the firmware attached in the format required by SAM-BA. I compiled it myself with the arm toolchain, though. The tricky part was switching to SAM-BA mode, what the wiki page says is true: sometimes it just not works ... After 3 or 4 attempts it worked.</div><div><br></div><div>I hope this helps.</div><div>Regards.</div><div><br>2016-10-16 22:28 GMT+02:00 Holger Freyther <<a href="mailto:holger@freyther.de" target="_blank">holger@freyther.de</a>>:<br>><br>><br>> > On 16 Oct 2016, at 22:15, Michael Kramer <<a href="mailto:michael.kramer@uni-konstanz.de" target="_blank">michael.kramer@uni-konstanz.<wbr>de</a>> wrote:<br>> ><br>> ><br>> > Am Freitag, 14. Oktober 2016 22:19 CEST, Holger Freyther <<a href="mailto:holger@freyther.de" target="_blank">holger@freyther.de</a>> schrieb:<br>> ><br>> >>><br>> >>> I've tried both dfu-utils 0.8 and 0.9 on a debian and kali machine. Haven't used SAM-BA yet. Should I try that as well?<br>> >><br>> >> SAM-BA is a lot more inconvenient and slower than dfu-utils. Could you try an older version of dfu-utils? E.g. I started with dfu-utils and probably still have this version around.<br>> ><br>> > Could you maybe check which version it was?<br>><br>> oh. I did and then didn't write it down. It was dfu-util 0.4 that I have used in<br>> the past.<br>><br>> holger<br><br><br><br>--<br>J. Félix Ontañón<br>Director of R&D<br>Podsystem Group<br></div></div>