<div dir="ltr"><div>Hi again.<br></div><div><br></div><div>I noticed a strange behaivour from RTL-SDR source in GNU-Radio 3.7.1</div><div><br></div><div>When sample rate is set to 900ksps, actual output sample rate is only 300 ksps.</div>
<div><br></div><div>You can check this easily connecting a RTL_SDR Source to a WX Gui FFT Sink and a RF signal generator.</div><div><br></div><div>For example, on RTL-SDR Source set sample rate to 900000 and frequency to 144000000 Hz.</div>
<div><br></div><div>On the WX GUI FFT Sink, set sample rate to 900000 and base frequency to 144000000 Hz.</div><div><br></div><div>Now apply a signal on 144.1 MHz. The FFT Display will show it at 144.3 MHz.</div><div><br>
</div><div>Apply a signal on 144.05 MHz. The FFT Display will show it at 144.15 MHz.<br></div><div><br></div><div>Now on the WX GUI FFT Sink, set sample rate to 300000 and repeat the above steps. The signal will be displayed at its right places.</div>
<div><br></div><div>Interestingly, setting sample rate to 1Msps works fine.</div><div><br></div><div>Tested with both E4000 and R820T dongles.</div><div><br></div><div>Any advice?<br><br>Thank you!</div><div><br></div></div>