<div dir="ltr"><div>Not sure if this is a repost, i just joined the list and i don't think i had confirmed my account when i sent it (the confirmation was in my spam). Anyways, not trying to be a bad list member.</div><div><br></div><div>I just picked up this IPAccess model which supports band 2/5 and 
has the same housing as the other units on the accelerate3g5 project 
docs. I've been pouring over docs and trying a lot of network 
configurations in my home lab. I have the login information for the 
factory reset and can access the web gui on port 8089 during the reset 
process, but ssh and telnet DMI seem to be disabled. I've been fuzzing 
ports and i've tried static as well as DHCP for IP addresses. <br></div><div>My
 thought was that if i point the nano3G to the IP of my osmo-hNodeB 
machine that it would at least stimulate the device and maybe i'd see 
some log messages in the HNodeB gateway, but so far i haven't seen 
anything in the logs. i've also tried abisip-find and that doesn't find 
anything.<br></div><div>Wireshark shows basic 'who has' Layer 2 messages
 and also DHCP requests sent to 0.0.0.0, both from the nano3g. The 
nano3g does get an ip from my lab router and i can ping it. The LAN 
behind that router can also access the 0.ipaccess ntp server, but again 
no telnet DMI or ssh so i'm unsure where to go from here.</div><div>Layer 1 seems to show nothing on the uarfcn in the web gui, so it seems that its not crossing all the right bridges. <br></div><div><br></div><div>I
 will admit, i haven't run any other osmo network components for the 
network, but as far as i was reading the home nodeb gateway and ntp should be 
the only things necessary to at least start the process.<br></div><div><br></div><div>Any insight on what to try next would be very helpful. Does anyone have experience with this model?</div><div><br></div><div>thanks</div></div>