<div dir="ltr">Hello all,<div><br></div><div>Brief question. Is it possible to debug E1 line by connecting it to the 2nd port of the same NIC making a wired loop? Is it enough to open->ioctl->read from /dev/dahdi/channel to get a stream of LAPD SABME messages transmitted by BSC?</div><div><br></div><div>A bit more details for those interested</div><div><br></div><div>I'm still trying to bring up BTS Nokia Flexi with OSMO-BSC. </div><div>I'm using an E1 card Digium TE405P on the server side.</div><div>OSMO-BSC is connected with Nokia BTS via a single E1 line.</div><div>Looks like on Level1 everything is ok because BTS can detect the link and raise an alarm if the wire is getting disconnected.</div><div>I can observe some data from timeslots on BTS side and if some channel is configured as D-Channel in /etc/dahdi/system I see transmission of block "01111110".   </div><div>But the problem is that LAPD link is not establishing. I can't find any tries on BTS side and BSC does not receive anything from BTS, just set of SABME messages in PCAP file.</div><div>T200 expires and so on. I tried various T200 values. So, now it looks for me like L1 does not receive anything from L2 on BSC side and nothing is transmitted over the wire to BTS.</div><div><br></div><div>dahdi_tool shows status "OK" </div><div><br></div><div>So, my nearest plan to check data transmission over wired loopback.</div><div><br></div><div>Thank you</div><div>Babanov Ivan </div></div>