<div>Hi,</div>
<div> </div>
<div>I have the OpenBSC up and running with a nanobts at 900MHz.</div>
<div>I would require some help with the following issues.</div>
<div> </div>
<div>1) I'm able to view most of the air interface messages on wireshark but not able to</div>
<div>view the gsm system information blocks. Is there any patches I should add on wireshark and is it possible</div>
<div>to provide instructions on how to apply the patches ?</div>
<div> </div>
<div>2) I'm able to see the rrlp request made to the mobile on wireshark. However I'm not</div>
<div>see any rrlp  response from the mobile on wireshark. I'm sure my mobile suppot ms-based rrlp request.</div>
<div>Again, what are the patches to wireshark I should apply? Appreciate if details on how to apply the patches</div>
<div>are provided.</div>
<div> </div>
<div>3) I have copied out the gprs branch and am able to run the gprs OpenBSC codes without any problems.</div>
<div>Just that at this stage, my mobile (i-phone 3Gs) does not seem to be able to do a gprs attach and have</div>
<div>the OpenBSC allocate it a P-TMSI. Is there any thing I should do to get my i-phone 3Gs to do a gprs attach on the</div>
<div>OpenBSC? (For my i-phone 3Gs, the settings is gsm mode only)</div>
<div> </div>
<div>4) Also in the OpenBSC folder, there's this rrlp-ephemeris folder, if possible, would like to have further details on </div>
<div>the purpose of the rrlp-ephemeris folder. </div>
<div> </div>
<div>Appreciate any kind advise and help.</div>
<div> </div>
<div>Thanks so much</div>
<div>Ken</div>
<div> </div>