Hello,<br><br>Now I can configure the bs11 using the bs11_config. Everything worked fine and I obtained this on bs11_config query :<br><br>LMT LOGON: ACK<br><br>PHASE: 3 Normal MBCCU0: Load MBCCU1: No Load Abis-link: Restoring<br>
<br>BS11 ATTRIBUTES:<br> BS-11 ESN PCB Serial Number: 001073<br> BS-11 ESN Hardware Code Number: 135-2044/03.03<br> BS-11 ESN Firmware Code Number: 135-2044/03.03<br> PLL Set Value=1053, Work Value=1053<br>
<br>SITE MANAGER ATTRIBUTES:<br> E1 Channel: Port=0 Timeslot=1 (Full Slot)<br> TEI: 25<br><br>BS11 Line Interface ATTRIBUTES:<br> PLL Mode: Standalone<br><br>BS11 Power Amplifier 0 ATTRIBUTES:<br> TRX Power: 30mW (GSM)<br>
Mon May 25 16:01:12 2009 <0020> abis_nm.c:811 GET ATTRIBUTE NACK<br>LMT LOGOFF: ACK<br><br><br>I didn't doanwload:<br>-the SAFETY LOAD software<br>-the BTS software<br>Is it necessary since I can reach Phase 3 and since I can see the Firmware Code Number?<br>
<br><br>I continued to follow the "getting started" tutorial untill the E1 Link and I have the following problem when launching bsc_hack :<br><br>./bsc_hack -f 123 --debug=DRLL:DCC:DMM:DRR:DRSL:DNM:DMI:DMUX:DPAG:DRLL:DSMS<br>
DB: Database initialized.<br>DB: Database prepared.<br>1 device found<br> id: 0<br> Dprotocols: 00000018<br> Bprotocols: 0000006e<br> protocol: 4<br> nrbchan: 30<br>
name: hfc-e1.1<br>activate bchan<br>activate bchan<br>Mon May 25 16:07:39 2009 <1000> input/misdn.c:125 alen =6, dev(0) channel(0) sapi(63) tei(127)<br>Mon May 25 16:07:39 2009 <1000> input/misdn.c:128 <= len = 12, prim(0x8) id(0x7f3f): DL_INFORMATION_IND<br>
Mon May 25 16:07:39 2009 <1000> input/misdn.c:135 DL_INFORMATION_IND: use channel(0) sapi(63) tei(127) for now<br>mISDN message for unknown sign_link<br><br><br><br><br>May be it's coming from my BN1E1 card from Beronet. I only changed the Dip switches for 120 ohms.<br>
I can see 2 steady red led (which means i am in NT mode, TE mode deactivate). Both green leds are off (is it normal?).<br><br>/* HFC-E1 OEM */<br>+ /* 2 red blinking: NT mode deactivate<br>+ * 2 red steady: TE mode deactivate<br>
+ * left green: L1 active<br>+ * left red: frame sync, but no L1<br>+ * right green: L2 active<br>+ */<br><br><br>Anyone?<br>Thanks in advance!<br><br>Best regards<br>Eric Cathelinaud<br>