<div dir="auto">This happens when the agc is turned on.  Bill Becks and I experimented with it a while back and found a way to enable/disable, but at this moment I don't recall the magic incantation.<div dir="auto"><br></div><div dir="auto">Graham</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sat, Sep 5, 2020, 7:23 AM  <<a href="mailto:op25@zellners.com">op25@zellners.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>
Quoting Graham Norbury <<a href="mailto:gnorbury@bondcar.com" target="_blank" rel="noreferrer">gnorbury@bondcar.com</a>>:<br>
<br>
> I'm not aware of a master gain parameter.   LNA, MIX, IF are the three gain<br>
> controls.  All take value between 0-15.<br>
><br>
>><br>
>> ./rx.py --args 'airspy' -N 'IF:10,MIX:5,LNA:15' -S 2500000 -f<br>
>> 774.55625e6 -v 7 -T P25PC.tsv -q 2 -V -2  -U -x 2 2>> airspy.log<br>
<br>
<br>
I reran my tests on this again, using -N 'IF:,MIX:,LNA:' like above  <br>
with 0-15 values.<br>
<br>
The spike for the CC, as a test, didn't budge at all, all 15, or  <br>
anything in between, no changes.<br>
<br>
It is significantly lower to start -20 to -40db lower v. other  <br>
programs and depending on antenna.<br>
<br>
Its almost like the gains are set to 0 or something and never  <br>
change??? ? ? ? ?<br>
<br>
Even using a duck direct to the Airspy with another program results in  <br>
much higher signals on its spectrum, and gains will adjust accordingly.<br>
<br>
Changes will occur in another program with adjustments to all 3  <br>
(outside its faked single slider mode, using just the REAL GAINS),  <br>
gains shows changes in the signals and noise floor.<br>
<br>
In op25, not a bit of change at all in any thing. noise or signal.  <br>
Like these are not being sent? Or not taking affect?? ? ? 15 for all,  <br>
combos of values, even things like 50 for all three, no changes.<br>
<br>
<br>
I am not sure what to even try at this point? Other than missing lib  <br>
when it was compiled??? I didn't have the airspy then or airspy  <br>
pacakges installed when compiled.. does that change anything??? It  <br>
seems to work regardless of that, it tunes, it will trunk, voice etc.,  <br>
just the gains don't seem to do a thing at all. IF there was something  <br>
missing in this, I would expect it to fail to tune, audio etc..<br>
<br>
Ideas?????<br>
<br>
<br>
<br>
</blockquote></div>