This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/op25-dev@lists.osmocom.org/.
Tom Hayward tom@tomh.us [op25-dev] op25-dev at yahoogroups.comI have an older system working fine on the master branch and I'm currently trying to set up a new VM running the max branch. The goal is to send audio from two talkgroups to darkice. The problem is that I'm not getting any audio out of rx.py. I know the darkice config works, because I can do this and hear pink noise on the stream: speaker-test -r 8000 -D hw:Loopback,0,0 But starting rx.py with the same audio device like this, I never hear anything: ./rx.py --args rtl=0 -N LNA:42 -f 774081250 -S 1320000 -v 5 -2 -T ss911_tacoma.tsv -O hw:Loopback,0,0 The receiver seems to be working. I can see the name of the talkgroup I'm interested in at the bottom of the screen while it's active, I just don't hear anything on the stream: """ NAC 0x1e1 WACN 0xbee00 SYSID 0x1e7 774.431250/804.431250 tsbks 2390 voice frequency 773.431250 tgid(s) 40306 40107 0.3s ago count 77 voice frequency 774.681250 tgid(s) 59197 40106 0.3s ago count 166 Frequency 774.431250 Talkgroup ID 40106 PCSO East """ Is there something obvious I'm doing wrong here? P.S. Is there a better way to pipe audio to darkice than snd-aloop? Tom -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.osmocom.org/pipermail/op25-dev/attachments/20171017/2881962d/attachment.htm>