<div dir="ltr"><div class="gmail_quote"><div dir="ltr" class="gmail_attr">Hi Sylvain,<br></div><div dir="ltr"><div><br></div><div>Thanks to your suggestions, I managed to decode the RACH from the captures on L-band. I just had to tweak a few parameters in the graphs. I have decoded the Paging Response and Location Update messages.</div><div><br></div><div>Do you have some suggestions on decoding the uplink speech? On the downlink, the code follows the Immediate Assignment and decodes the traffic channel. Due to the limitation of the SDR, I am not able to capture both the downlink and uplink channels simultaneously.</div><div><br></div><div>Thank you again.</div><div><br></div><div>Best regards,</div><div>Johann</div><div><br></div><div><br></div><div><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Tue, May 25, 2021 at 7:26 PM Sylvain Munaut <<a href="mailto:246tnt@gmail.com" target="_blank">246tnt@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Hi,<br>
<br>
> I have made some captures on the L-band uplink channels and tried to decode the RACH messages. All four consecutive TCH channels (according to the spot beam) were recorded and a call was made during the recording.<br>
><br>
> I am using the GRC block gmr_rach_scan.grc. I have removed the IQ swap from the graph, as suggested in the mailing list. The sampling rate and samples-per-symbol values have  been set to 93.6k and 4, respectively.<br>
<br>
Oops, looks like I complete missed this ... sorry.<br>
<br>
That graph was made to scan large bandwidth capture for RACH ... It's<br>
very probable that a bunch of constants and thresholds value are just<br>
not appropriate for a narrow band capture.<br>
It kind of always required tweaking depending on the case. Basically<br>
manually finding a RACH (in frequency and time), then look at all the<br>
intermediate steps of the graphs (and possibly inside the block) to<br>
see if it detects that particular one and tweak it until it does. And<br>
then you can run it to find the other ones.<br>
<br>
I don't have any setup any more to capture C-band uplink so I have not<br>
run that graph in years .... but that's all I remember about it.<br>
<br>
Cheers,<br>
<br>
  Sylvain<br>
</blockquote></div>
</div></div>