<div dir="ltr">Dear all,<div><br></div><div>In the past weeks, I have been playing with the Osmocom GMR code. The code has been successfully compiled and installed.</div><div><br></div><div>My intention is to listen to the broadcast channel of Thuraya in the Netherlands. There are two spotbeams for NL namely 288 and 289. As I am located at the border of the two beams, I have tried both options. So far I couldn't see anything decoded in Wireshark.</div><div><br></div><div>I noted that the translation of ARFCN to frequency is slightly different in the formula by Driessen (Practical cryptanalysis of the real world systems) and in the ETSI standard (TS 101 376-5-5). There is a shift of half of the channel bandwidth (31.25 kHz).</div><div><br></div><div>For your information, I am using Ubuntu 16.04, USRP B210, a wideband antenna and LNA with about 20 dBi gain on L-band. </div><div><br></div><div>As mentioned by Sylvain in the mailing list, the gmr_multi_rx.py is obsolete. I am using the gmr1_rx_sdr.py for my tests.</div><div><br></div><div>I ran the following commands (one each time) and with Wireshark listening to lo interface while applying the gmr1.bcch filter.  Is this the right approach as I don't see anything show up so far? Did I overlook something here?</div><div><br></div><div>Spotbeam 289 (ARFCN 1007)<br>./gmr1_rx_sdr.py -s 10000000 -B L -f 1556484375 -a 1007 -g 45 (Driessen)<br>./gmr1_rx_sdr.py -s 10000000 -B L -f 1556468750 -a 1007 -g 45 (ETSI)<br></div><div><br></div><div>Spotbeam 288 (ARFCN 267)<br>./gmr1_rx_sdr.py -s 10000000 -B L -f 1533359375 -a 267 -g 45 (Driessen)<br>./gmr1_rx_sdr.py -s 10000000 -B L -f 1533343750 -a 267 -g 45 (ETSI)<br></div><div><br></div><div>Comments or suggestions are much appreciated. Many thanks in advance.</div><div><br></div><div>Best regards,</div><div>Johann</div><div><br></div><div><br></div><div><br></div><div> </div></div>