Change in osmo-bsc[master]: paging: Add VTY options to calculate T3113 timeout dynamically
Pau Espin Pedrol
gerrit-no-reply at lists.osmocom.org
Fri Nov 9 15:41:27 UTC 2018
Hello Neels Hofmeyr, Harald Welte, Jenkins Builder,
I'd like you to reexamine a change. Please visit
to look at the new patch set (#2).
Change subject: paging: Add VTY options to calculate T3113 timeout dynamically
paging: Add VTY options to calculate T3113 timeout dynamically
The idea is to have a base static value which is set like before "timer
t3113 [seconds]", but now have a part of this timeout calculated
dynamically based on BTS channel configuration and channel load.
This patch only implements initial support to calculate based on channel
configuration, but doesn't include code to calculate based on channel
load. To implement the later part, we probably need to keep track of BTS
paging queues per paging group, which we don't do nowadays.
Dynamic calculation is enabled by default, and default static base value
is decreased accordingly. This way, in a typical setup were the default
10 seconds were used, now the calculated final value is 11 seconds.
That's intended because it was observed experimentally in osmo-gsm-tester with
a similar channel setup that sometimes paging response can arrive slightly
later than 10 seconds.
7 files changed, 83 insertions(+), 5 deletions(-)
git pull ssh://gerrit.osmocom.org:29418/osmo-bsc refs/changes/54/11654/2
To view, visit https://gerrit.osmocom.org/11654
To unsubscribe, or for help writing mail filters, visit https://gerrit.osmocom.org/settings
Gerrit-Owner: Pau Espin Pedrol <pespin at sysmocom.de>
Gerrit-Reviewer: Harald Welte <laforge at gnumonks.org>
Gerrit-Reviewer: Jenkins Builder (1000002)
Gerrit-Reviewer: Neels Hofmeyr <nhofmeyr at sysmocom.de>
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the gerrit-log