This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/gerrit-log@lists.osmocom.org/.
Harald Welte gerrit-no-reply at lists.osmocom.orgHarald Welte has submitted this change and it was merged. Change subject: network: use originating RTP packet address for loopback ...................................................................... network: use originating RTP packet address for loopback When a connection is created in loopback mode all incoming packets should be reflected back to their origin. If the user did not supply a destination address with the CRCX command all incoming packets will be tossed because no destination address is officially known yet. If there is no destination address set and the connection is in loopback mode. Then use the originating address of the incoming packet as destination address. Change-Id: I3d1abe56d016e28c97f60635eb574679d36e2c52 --- M src/libosmo-mgcp/mgcp_network.c 1 file changed, 9 insertions(+), 0 deletions(-) Approvals: Harald Welte: Looks good to me, approved Jenkins Builder: Verified diff --git a/src/libosmo-mgcp/mgcp_network.c b/src/libosmo-mgcp/mgcp_network.c index eb44f9b..aac3e51 100644 --- a/src/libosmo-mgcp/mgcp_network.c +++ b/src/libosmo-mgcp/mgcp_network.c @@ -1077,7 +1077,16 @@ /* Check if the connection is in loopback mode, if yes, just send the * incoming data back to the origin */ + if (conn_src->conn->mode == MGCP_CONN_LOOPBACK) { + /* When we are in loopback mode, we loop back all incoming + * packets back to their origin. We will use the originating + * address data from the UDP packet header to patch the + * outgoing address in connection on the fly */ + if (conn_src->end.rtp_port == 0) { + conn_src->end.addr = addr.sin_addr; + conn_src->end.rtp_port = addr.sin_port; + } return mgcp_send_rtp(proto, &addr, buf, len, conn_src, conn_src); } -- To view, visit https://gerrit.osmocom.org/5298 To unsubscribe, visit https://gerrit.osmocom.org/settings Gerrit-MessageType: merged Gerrit-Change-Id: I3d1abe56d016e28c97f60635eb574679d36e2c52 Gerrit-PatchSet: 1 Gerrit-Project: osmo-mgw Gerrit-Branch: master Gerrit-Owner: dexter <pmaier at sysmocom.de> Gerrit-Reviewer: Harald Welte <laforge at gnumonks.org> Gerrit-Reviewer: Jenkins Builder