Hi,<br /><br />> Ah, good.  It looks like you had to change trf6151_pll_tx() quite a bit.<br />> Is there anything there that you are unsure of?  Something I can test?<br /><br />No, I looked at it again this morning and it looks fine.<br /><br />You can try to enable the warning (define at the top of the file)<br />It shouldn't throw any (check that DCS is disabled in your mobile config or else it will throw some when doing power measurement in a bad band for your phone).<br /><br /><br />> > But obviously I couldn't test with a real BTS (because I'm not in the US<br />> > and the racal 6103e doesn't support GSM850)<br />> <br />> I'll experiment with OpenBTS and try both GSM900 and GSM850<br />> configurations.<br /><br />Ah yes, I guess I could test with OpenBTS as well.<br /><br /><br />> Well, I can monitor the uplink frequency and compare the signal<br />> amplitude between the standard Motorola firmware and the osmocom code.<br />> If there is still a weak signal problem, it should be fairly obvious.<br /><br />Yes, but with _fft software alone it's not easy because RACH is very short and so what you see on the screen is not really the power.<br />A real analyzer can be set to trigger on power level to capture 'only' the RACH and analyze the power in that.<br /><br />A time graph might work tough. (or possibly waterfall with a very short fft size).<br /><br /><br />> If you have any other ideas, I'd be glad to test them out.  I'll at<br />> least try the above and figure out how strong the tx signal is.  Not<br />> sure what I can do after that though.<br /><br />You can look at the parameter chosen in the trf pll settings (A / B / Band) and post them here along with the ARFCN so I can check if they've been selected correctly.<br /><br />I don't have much other ideas.<br /><br />Cheers,<br /><br />    Sylvain