On Wed, Jun 17, 2009 at 04:38:13PM +0200, Andreas.Eversberg wrote:
I am not
sure if you will get the measurement reports for an active
connection by default or if they have to be turned on with a "Start
Measurement" command over OML.
it's part of the BTS or TRX attributes that are set from the BSC.
NM_ATT_BS11_RADIO_MEAS_REP, 0x01, 0x01,
measurement report is enabled in msg_6[], but no report messages during
call or setup. this TRX-config seems to tell the mobile to send reports.
what do i need to tell the BTS to forward the reports to BSC?
I see them all the time. That's really weird. I didn't test with BS-11
for a long time, but I distinctively remember having seen them at some time
in the past.
I'm not much in Berlin during the next 5-6 weeks, so it's unlikely that I'll
be
working on the BS-11 for quite some time, sorry.
--
- Harald Welte <laforge(a)gnumonks.org>
http://laforge.gnumonks.org/
============================================================================
"Privacy in residential applications is a desirable marketing option."
(ETSI EN 300 175-7 Ch. A6)